JiaYuan sky spy Bedienungsanleitung Seite 5

9. FLYING PRACTICE
To maximise your enjoyment of this model, why not practice
these four manoeuvres?
Rotate Left or Right
Landing in a precise spot
10. BINDING THE TRANSMITTER TO THE HELICOPTER
Please be sure to carry out the initial binding of the helicopter to the transmitter by following the steps
below
1. Firstly, please switch the power to the helicopter and transmitter OFF.
2. Place the helicopter on a lat surface and switch it on. The LED on the helicopter's receiver will
illuminate indicating that it is trying to ind a transmitter to bind with.
3. Ensure the throttle on the transmitter is in its lowest position (stick pulled back) and then switch
ON the transmitter. An LED light will indicate the transmitter is ON. A buzzer will send out a ''di di"
sound to show that a bind is in progress. When the bind process (which is automatic) is complete,
the sound will stop. DO NOT switch off either the helicopter or transmitter, as this will lose the
binding process and you will need to begin again.
4. The helicopter is now ready for use, assuming it has not been turned OFF after this process.
(Simply repeat the steps each time the helicopter is switched ON).
5. When using multiple helicopters at the same time, ensure each one is bound in turn, but DO NOT
switch any OFF.
1
First of all, switch
the Helicopter ON
Practice lying in a square
pattern which as your skill
develops, can be turned into
a circle.
Now that your skill has
developed further, try
lying in a igure of 8.
5
2
Switch ON
the Power
with the
throttle stick
in the low
position