Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
SwITchING ThE Tv oN/oFF /
oPERATING ThE Tv
SwITchING ThE Tv oN/oFF
To switch the Tv on
Your TV will switch on in two steps:
1- Press the power button located on the front of the
TV. Then the TV switches itself to stand-by mode and
the LED located below becomes RED.
2- To switch on the TV from stand-by mode either:
Press a digit button on the remote control so that a
programme number is selected,
or,
Press Programme Up or Down buttons on the front
of the TV or on the remote control, so that last
switched off programme is selected.
By either ways the TV will switch on and the LED will
turn off.
To switch the Tv off
• Press the stand-by button on the remote control, so
the TV will switch to stand-by mode and the LED will
become Red,
or,
Press the power button located on the front of the
TV, so the TV will switch off.
oPERATING ThE Tv
You can operate your Tv both using the remote
control handset and onset buttons.
operating with the buttons on the Tv set
Volume setting and programme selection can be made
using the buttons on the front panel.
operating with Remote control
The remote control handset of your TV is designed to
control all the functions of the model you selected. The
functions will be described in accordance with the menu
system of your TV.
volume Setting
Press "V+" button to increase volume.
Press "V-" button to decrease volume. A volume level
scale (slider) will be displayed at the middle of the
bottom on the screen.
Programme Selecting
(Previous or next programme)
• Press "P+" button to select the previous programme.
• Press "-P" button to select the next programme.
Programme Selecting (direct access)
Press digit buttons on the remote control handset to
select programmes between 0 and 9. TV will switch
to the selected programme. To select programmes
between 10 - 99, you must use the double digit button
„- -". This OSD is displayed at the left hand upper on
the screen.
After then, press the digit buttons consecutively which
programme you want to select (e.g. For programme 27,
first press 2 and then 7). When it is late to press any
digit button this function will be ignored and the display
will be erased. In the same way it must not be late to
press any digit button after entering the first digit. The
limit of the delay time is seconds.
Press directly the programme number to reselect single
digit programmes.
Programme Swapping
• Press „P<P" (programme swap) button to select the
last selected programme. This button provides
swapping between last two selected programmes.
For example, select programme 8, then select
programme 2. Now, if you press „P<P" button,
programme 8 will be selected. If you press the same
button again, programme 2 will be selected and
so on.
25
GB
Werbung
Kapitel
Inhaltsverzeichnis
