Turning Power On/Off; Turning On The Main Power - Sharp PN-Y326 Installationsanleitung

Caution
• Turn on the monitor first before turning on the computer or
playback device.
• When switching the main power switch or the POWER
button off and back on, always wait for at least 5 seconds.
A short interval may result in a m a lfunction.

Turning on the main power

When the main power is turned on, the power LED lights. Wait
until the screen is displayed.
Main power switch
Caution
• The main power must be turned on/off with the main power
switch. Do not connect/disconnect the power cord or turn
the breaker on/off while the main power switch is on.
• For a complete electrical disconnection, pull out the main
plug.

Turning power on/off

Press the POWER button to turn the power ON/OFF.
Power LED
Status
Green lit
Orange lit
Green flashing
Turning Power On/Off
POWER button
Status of the monitor
Power on
Power off (Standby mode)
Input signal waiting mode
nOperation mode
When the monitor is turned on for the first time after being
shipped from the factory, the operation mode setting screen
will be displayed. Set it to MODE1 or MODE2.
MODE1 ... OFF IF NO OPERATION is set to ON, and
POWER SAVE MODE is set to ON. (These settings
can not be changed.)
Determines whether or not to set the monitor to
go into standby mode when there is no operation
from the remote control unit, or LAN for over 4
hours. Power consumption in standby mode is also
minimized.
MODE2 ... Will perform standard operation.
OFF IF NO OPERATION is set to OFF, and
POWER SAVE MODE is set to OFF. These
settings can be changed.
Even after being set, changes can be made using
OPERATION MODE, located in the menu of the monitor. (See
OPERATION MANUAL.)
When you use SHARP Content Distributor, set OPERATION
MODE to MODE2.
nDate/time setting
• If the time has not been set, such as when the monitor
is first turned on, set the date and time in DATE/TIME
SETTING of the SETUP menu.
Be sure to set the date and time.
TIPS
• Set the time on a 24-hour basis.
• The clock stops if the main power remains off for about 1
week.*
(* Approximate time. The actual time varies depending
on the state of the monitor.)
7
E