Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1, Manual 2, Sound Active 3, DMX
Manual Mode
To run the Strobe in Manual mode, set all dip switches to the "OFF" position.
In manual mode the unit will function as a normal strobe light, Rate (speed) and intensity
(brightness) are set directly on the unit. Note that these settings are made by using the
controls on the rear of the unit. Once the settings are made they can only be changed by
physically adjusting the controls on the unit. Be aware of this if you plan on installing your
strobe in a permanent installation.
Flash speed is controlled via the SPEED control
Flash dimming is controlled via the DIMMER control.
Sound active Mode
To run the Firecracker Strobe in Sound active mode, set dip switch 9 to the "ON" position.
The Dimming will still be controlled by the DIMMER control on the back of the unit. Note
that these settings are made using the controls on the rear of the unit. Once the settings
are made they can only be changed by physically adjusting the controls on the unit. Be
aware of this if you plan on installing your strobe in a permanent installation.
Flash Dimming is controlled via the DIMMER control.
Flash Speed is controlled by the Music
DMX Mode
To run the Strobe into DMX mode, set dip switch 10 to the "ON" position. You can now set
the required DMX address using dip switches 1 to 9. The start address for this fixture is 1.
Please refer to the chart below for DMX functions.
DMX Chart
This unit obtains 2 DMX channels and can match to use with any international standard
DMX512 controller.
CH1: STROBE (speed)
CH2: DIMMER (0-100%)
Maintenance:
Always disconnect the electric mains power supply before cleaning or servicing. Damages
caused by non-observance are not subject to warranty.
The DMX Strobe requires almost no maintenance. However, you should keep the unit
clean.
Wipe the cover with a damp cloth.
Do not immerse in liquid.
Do not use alcohol or solvents
Make sure the equipment is fully dry before re-connecting to the mains.
Werbung
