Installation Mercedes Comand Aps Ntg2 - IMU Dietz 1540 Bedienungsanleitung

Installation MERCEDES COMAND APS NTG2

1. Switch off ignition and remove the key.
2. Remove and disconnect the head unit.
3. Release the fibre optic cables from the main MOST
small connector (pic.2). Afterwards push out the blue locking (pic.3), and then pull out the fibre optic from
the output (!) (see the right arrow on pic.4), while carefully bending the clip with a small screw driver. Then
put this fibre optic into the connector from the enclosed fibre optic cable kit (pic.5, this connector must lead
to the input of IMU 1540 on its' other end via the fibre optic!!)The remaining fibre optic without connector
now has to be plugged into the open slot (pic.6). With that, the fibre optic ring must be closed entirely again!
4. Re-connect the small fibre optics connector with the MOST
5. Connect the remaining fibre optics connector (pic.7) with the counterpart
at the IMU 1540.
6. Now connect the black wire from the harness with ground,
and the red one with "permanent" +12V.
7. Connect RCA jacks - A: audio left (black), B: audio right (red),
with the audio output of the video source. The yelllow
RCA jack (C) is only used when the video source delivers
a NTSC signal. Information on connection can also be found
on page 16. Connection with the video source should only
be done with a high quality RCA video cable, otherwise the
picture quality could be bad, caused by a weak video signal.
The video output signal (CVBS) is fed into the head unit
directly by using the enclosed "green FAKRA to RCA jack"
adapter (see picture).
8. If it is intended to use the BOA DVD player 85700, the control cable kit 1479 has to be connected with its'
counterpart at the video source and the IMU 1540.
®
connector of the head unit (pic.1), and pull out the
®
Copyright © by Audiotechnik Dietz Vertriebs-GmbH ● Germany
Rev. 0 Stand: 05 / 2008
®
main connector.
17
E
N
G
L
I
S
H