Installation - IMU Dietz 1540 Bedienungsanleitung

Installation

The interface can be used with the following navigation systems, if
dismount:
MERCEDES:
A-W169, B-W245
C-W203 & CLK-W209 04/04~
M-W164, GL-X164
R-W251,Vito
MERCEDES:
E-W211
CLS-W219
For control BOA DVD Player 85700 additional cable kit 1479 is necessary.
* E-W211 up to 02/2004 or with former OEM TV tuner, CLS-W219 with former TV tuner,
respectively only COMAND units having the video input (green FAKRA connector at the back side,
see picture below).
The interface can only be used without (!) the original TV tuner!
If a COMAND APS NTG2 unit is delivered without any connected MOST
changer...) and therefore has no fibre optics plugged into the main connector, it first has to be
programmed via Star diagnostic at a Mercedes-Benz garage to open its' MOST
1540 cannot be recognised by the COMAND. In this case the COMAND has to be programmed with
component 1 set to "AGW", component 2 set to e.g. phone, CD changer..., the last component finally has
to be set to "COMAND".
ATTENTION: The interface IMU 1540 installed in a Mercedes can not be recognized with the diagnostic
system! For this reason There should not be programmed a TV tuner, as this causes the system to put out
the error code "TV not found". For a proper working of the interface IMU 1540, it is sufficient to let the
COMAND just open its' MOST
car
MERCEDES COMAND APS NTG1
®
ring.
Copyright © by Audiotechnik Dietz
Rev. 0 Stand: 05 / 2008
no
OEM TV tuner is installed or is
head unit
COMAND APS
NTG2
COMAND APS
NTG1*
®
components (like phone, CD-
®
ring. Otherwise the IMU
®
Vertriebs-GmbH ● Germany
15
E
N
G
L
I
S
H