Time Setup; Display Mode - Peaq PPA250-B Bedienungsanleitung

31

TIME SETUP

1. Press the ALARM.S button on the re-
mote control. TIME will be displayed.
Press the ENTER button.
2. The hour digits will flash. Press
buttons to adjust the hour. Press ENTER
to confirm.
3. Next the minutes digits will flash. Press
the or buttons to adjust the min-
utes. Press ENTER to confirm. Please
note that this clock is a 24 hour clock.
NOTE: Touch +/- on the front panel of the
unit or press or on remote control to
adjust the hour or minutes.
SLEEP
Press the ALARM.S key twice. Current
sleep setting is displayed, the indicator icon
will flash. Press ENTER to confirm. Press
or to increase and decrease sleep
intervals (5 min. steps from 00 to 30 min., 10
min. steps from 30 to 90 min.).
ALARM
1. Press the ALARM.S button on the re-
mote control three times. ALM is dis-
played and alarm icon will flicker. Press
the ENTER button to confirm.
2. ON will flicker on the display window.
Press the ENTER button to confirm.
3. To turn the alarm settings off, follow the
steps above and press the
switch from ON to OFF.
4. Once ON is confirmed, the hour digits
will flicker on the screen.
5. Use the or to select the hour of
choice (please note that clock is a 24
hour clock).
6. Confirm hour selection by pressing the
ENTER button.
7. The back 2 digits ( minute selection) will
flicker.
8. Use the
utes.
9. Press ENTER button to confirm.
10. Once minute selection has been con-
firmed, the system will then prompt
or four alarm options. Use the
to scroll through the options and press
ENTER to confirm.
11. During the operation of alarm settings,
if the interval time exceeds 6 seconds,
the current setting will be cancelled.
12. To halt the alarm when alarm rings.
a. Press STANDBY button on the re-
mote control to cancel the alarm directly.
b. Touch any button on the front pan-
el or remote control twice to cancel
alarm.
13. Press the STANDBY key once to turn
the unit on, once alarm has been si-
lenced.
SNOOZE
Touch any button on the front panel or press
any button except STANDBY button on the
remote control once, the alarm stops ring-
ing and the unit enters into SNOOZE mode.
Both SNOOZE and ALARM icons blink when
the unit is in SNOOZE mode, the alarm stops
ringing for 9 minutes, then continues to beep
as a reminder.
SNOOZE mode can be cancelled by press-
ing STANDBY on remote control or VOL+
and VOL– simultaneously on touch panel.
button to

DISPLAY MODE

Press the Display Mode button to turn
the Clock Display ON or OFF (in Standby
Mode).
ENGLISH
or to select the min-
or