Important Safety Instructions; Getting Started - XtremeMac Tango TRXD Bedienungsanleitung

ImPortant saFetY InstructIons

1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water - This apparatus shall not
be exposed to dripping or splashing, and no objects filled with
liquids, such as vases, shall be placed on the apparatus.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance
with the manufacturer's instructions. The apparatus should
not be situated on a bed, sofa, rug or similar surface that may
block the ventilation openings.
8. Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifiers) that
produce heat.
9. No naked flame sources, such as lighted candles, should be
placed on the apparatus.
10. Protect the power cord from being walked on or pinched—
particularly at plugs, convenience receptacles, and the point
where they exit from the apparatus.
11. Do not install in an area which impedes the access to the
power plug. Disconnecting the power plug is the only way to
completely remove power to the product and must be readily
accessible at all times.
12. Power source—Use only the power supply that is included
with this unit. Do not substitute with any other power supply.
13. Unplug this apparatus during lightning storms or when
unused for long periods of time.
14. Refer all servicing to qualified service personnel. Servicing is
required when the apparatus has been damaged in any way,
such as power-supply cord or plug is damaged, liquid has been
spilled or objects have fallen into the apparatus, the apparatus
has been exposed to rain or moisture, does not operate
normally, or has been dropped. For service, refer to qualified
service personnel, return to the dealer, or call the XtremeMac
service line for assistance.
6
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This class B digital apparatus complies with Canadian ICES-003.
Note: Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.

gettIng starteD

1. Remove unit, AC adapter and remote from the box and
properly dispose of any plastic or foam packaging material.
2. Place unit on a level surface close to a power outlet following
the precautions listed in the safety warnings.
3. If located in the US, skip to step 6. If located outside the US,
select the appropriate wall adapter. If already attached to the
unit, skip to step 6.
4. Press the button labeled "open" under the wall adapter to
release the adapter.
5. Gently slide in the appropriate wall adapter. You will hear a
click when it is properly locked into place.
6. Connect the AC adapter jack to the back of the unit labeled
power and then connect the other end of the adapter to a
power outlet.
7