Kress Mission Benutzerhandbuch Seite 11

Mission can be charged manually without the
TM
boundary wire.
1. Connect the charging base to a suitable power
supply. The green light on the charging base will
turn on.
2. Manually dock the Mission
base while the Mission
3. The green light on the charging base will turn to
red. Mission will begin to charge.
TM
4
Winter Hibernation
Your Mission will live longer and healthier if it is allowed to hibernate. So even though it is tough, we
TM
recommend storing your Mission
Before you prepare your Mission
• Thoroughly clean your Mission
• Fully charge the battery
• Turn the power off
To maximize the battery life, fully charge the battery before storage during winter.
WARNING: Protect the underside of Mission
outdoors.
The boundary wire can be left in the ground although its ends should be protected, such as placed in a tin can
with grease. If the charging base is left outside for the winter, leave the boundary wire connected.
NOTE: When bringing the Mission
contact pins are clean. We recommend using a fine grade emery cloth to clean the contacts. Using the app,
make sure the date and time are correct and send Mission
5
Replacing the battery
WARNING: Power off before attempting any adjustment, replacement or repair.
Before replacing the blades, turn your Mission
If you need to replace the battery, follow these
steps:
1. Gently turn your Mission
2. Remove the screws on the battery cover.
Remove the battery cover.
into the charging
TM
is powered off.
TM
in your shed or garage during the winter.
TM
for winter hibernation, we recommend you:
TM
TM
back to work after winter hibernation, make sure the charging strips and
TM
upside down.
TM
from water. NEVER store Mission
TM
back to what it loves doing: mowing.
TM
OFF and put on protective gloves.
TM
upside down
TM
11
EN