Technical Data; Maintenance - Rev Ritter 93238 Montage- Und Bedienungsanleitung

GB

TECHnICAL DATA

• Voltage:
• Type:
• Illuminant:
• Luminous flux:
• Colour temperature:
• Protection class:
InSTALLInG THE HAnDLE AnD BASE (see 1,2 and 3)
• Loosen the wing nut on the support and insert the base into the handle.
Insert the wing nut into the hole provided on the handle and tighten it.
SETTInG THE FLOODLIGHT DIRECTIOn
• Loosen the screws on the sides underneath the housing and adjust the
floodlight direction – ensure that the handle is not illuminated – and then
retighten all screws.
The floodlight is now ready for use and can be operated under the intended
conditions – it is essential that the requirements specified under "General
Safety Instructions" in regards to the installation location are followed.
CLEAnInG
• Before cleaning the LED floodlight, disconnect the power cable and allow
the floodlight to cool down sufficiently.
• Clean with a dry or slightly moist, clean, lint-free cloth and a mild detergent
if required. Do not use cleaners that contain abrasives or solvents.

MAInTEnAnCE

• Check the plug, power cable, and housing of the LED floodlight for damage
before each use. If the lens is damaged it must be replaced immediately.
• Clean any dirt from the housing or the lens immediately, since it could
cause overheating.
8
230V~, 50Hz
93238
20W LED Chip
approx. 1400lm
6500K
IP44