Hama Quick Charge Bedienungsanleitung Seite 3

Warning
• Only connect the product to a socket that has been approved for the device. The socket must
be installed close to the product and easily accessible.
• Do not continue to operate the device if it becomes visibly damaged.
4. Startup and Operation
Note – Connecting terminal devices
• Before connecting a terminal device, check whether the power output of the charger can
supply sufficient power for the device.
• In principle, all terminal devices whose power consumption does not exceed 1670 mA can be
charged. Terminal devices that support Quick Charge 2.0 charge considerably faster.
• Please refer to the instructions in the operating manual of your terminal device.
Note – 100-240 V mains voltage
• The charger is suitable for a mains voltage of 100-240 V and can be used around the world.
Please note that a country-specific adapter may be necessary.
• You can find an appropriate selection of Hama products at www.hama.com.
• Plug the charger into an approved and easily accessible electrical socket.
• Connect the terminal device to be charged to the USB port using the included Micro-USB cable or
a suitable USB cable.
• Disconnect all cable and mains connections after use.
5. Maintenance and Care
Only clean this product with a slightly damp, lint-free cloth and do not use aggressive cleaning
agents. Ensure that no water intrudes the product.
6. Warranty Disclaimer
Hama GmbH & Co. KG assumes no liability and provides no warranty for damage resulting from
improper installation/mounting, improper use of the product or from failure to observe the operating
instructions and/or safety notes.
3