Fax +32 2 359 95 50
When using the appliance under an extractor hood, make sure to observe the minimal
distance advised by the producer. It is even wiser to double this distance.
Immediately unplug the appliance if a crack appears and make sure it is controlled by a
qualified competent electrician(*).
Your appliance must never be switched on through an external timer or any kind of
separate remote control system.
(*) Competent qualified service: after-sales department of the producer or importer or any
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In case of need you should return the appliance to this service.
SHORT CORD INSTRUCTIONS
A short power supply cord is provided to reduce the risk resulting from becoming entangled in,
or tripping over a longer cord. Extension cords may be used if care is exercised in their use.
Please pay attention to the following:
The diameter of the extension cord must correspond to the one of the power cord of the
appliance, in other words, it must be suitable for at least 16 ampere. Extension cords for a
lower amperage could overheat.
The longer cord should be arranged so that it will not drape over the counter top or table
top, where it can be pulled on by children or tripped over.
BEFORE USE
Unpack the appliance and accessories, then wash and wipe these accessories.
It is normal if some smoke or smell emanates from the appliance when using it for the first
time. Therefore, we advise you to use your appliance empty once before the first use. If
you want to use the oven, put the function selector switch (C) in position
the temperature knob (D) to the maximum position (250) for about 10 minutes. This way,
the invisible protective coating of the heating elements will be burned. If you want to use
the cooking plates, preheat them during 10 minutes by turning their temperature knob to
the maximum position.
Just like with a traditional cooker, the functions of this appliance can be used individually (thus
oven only or cooking plates only) but you can also use both functions simultaneously.
USING THE OVEN
Operation
When using for the first time, clean the surface of the tray with a damp cloth and wipe dry.
Then grease the tray with butter, margarine or cooking oil.
Put the crumb tray on the bottom of the oven cavity.
Put the baking tray or the rack at the desired level inside the oven.
Plug the unit into the power supply socket.
To turn on the oven, turn the function selector switch (C) of the control panel to the
desired position:
: only the lower heating element heats up to bake or reheat a preparation without
-
roasting it.
: only the upper heating element heats up in order to roast the preparation.
-
: both heating elements will heat up to bake and roast the preparation.
-
The indicator lamp of the switch will light up.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
10
Assembly page 10/40
and turn
TEAM OTK 2 NB - 100826