Eliminating Minor Faults Yourself - NEFF KI12 Serie Gebrauchsanleitung

en

Eliminating minor faults yourself

Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice – even if the appliance is still under
guarantee!
Fault
Temperature differs
greatly from the set
value.
Displays
do not illuminate.
The light
does not function.
Bottom of the
refrigerator
compartment is wet.
The temperature in
the refrigerator com-
partment is too cold.
Appliance is not
cooling, temperature
display and light
are lit.
30
Possible cause
Power failure; the fuse
has been switched off;
the mains plug has not
been inserted
properly.
The LED light
is defective.
Appliance was open
too long.
Light is switched off
after approx. 10 min.
The condensation
channel or drainage
hole are blocked.
Temperature has been
set too low.
Showroom mode is
switched on.
Remedial action
In some cases it is adequate
to switch off the appliance
for 5 minutes.
If the temperature is too high wait a
few hours and check whether
the temperature has approached
the set value.
If the temperature is too low check
the temperature again the next day.
Connect mains plug. Check whether
the power is on, check the fuses.
See chapter "Light (LED)" section.
When the appliance is closed
and opened, the light is on again.
Clean the condensation channel
and the drainage hole. See chapter
Cleaning the appliance. Fig. #
Increase the temperature.
Hold down temperature selection
button fig. "/3 for 10 seconds until
an acknowledgement signal sounds.
After a short time check whether
your appliance is cooling.