Closing The Door; Technical Data; Installation; Electrical Connection - AEG SKS81040F0 Benutzerinformation

6.1 Replacing the lamp
The appliance is equipped with a long-
life LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service
Center.

6.2 Closing the door

1. Clean the door gaskets.

7. TECHNICAL DATA

Dimension of the recess
Rising Time
Voltage
Frequency
The technical information are situated in
the rating plate on the internal left side
of the appliance and in the energy label.

8. INSTALLATION

8.1 Positioning
WARNING!
If you are discarding an old appli-
ance that has a lock or catch on
the door, you must ensure that it
is made unusable to prevent
young children being trapped in-
side.
The appliance shall have the
plug accessible after installation.
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
2.
3.
Height
Width
Depth
Cli-
mate
class
SN
N
ST
T

8.2 Electrical connection

Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic pow-
er supply.
If necessary, adjust the door. Refer
to "Installation".
If necessary, replace the defective
door gaskets. Contact the Service
Center.
1030 mm
560 mm
550 mm
12 h
230-240 V
50 Hz
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
ENGLISH
29