Closing The Door; Installation - AEG SKS68808F1 Benutzerinformation

Problem
Water flows on the
rear plate of the re-
frigerator.
Water flows into the
refrigerator.
The temperature in
the appliance is too
low/high.
The temperature in
the freezer is too
high.
There is too much
frost.
If your appliance is still not working
properly after making the above checks,
please contact the After Sales Centre.
7.1 Replacing the control unit
The appliance is equipped with a long-
life LED interior light.
Only service is allowed to replace the
control unit. Contact your Service Cen-
ter.

8. INSTALLATION

WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
8.1 Positioning
This appliance should be installed in a
dry, well ventilated indoor where the am-
Possible cause
The food temperature is
too high.
The room temperature is
too high.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The water outlet is clog-
ged.
Products prevent that wa-
ter flows into the water
collector.
The temperature regula-
tor is not set correctly.
Products are too near to
each other.
Food is not wrapped cor-
rectly.
The door is not closed
correctly.

7.2 Closing the door

1.
2.
3.
bient temperature corresponds to the
climate class indicated on the rating
plate of the appliance:
Solution
Let the food temperature
decrease to room temper-
ature before storage.
Decrease the room tem-
perature.
This is correct.
Clean the water outlet.
Make sure that products
do not touch the rear
plate.
Set a higher/lower temper-
ature.
Store products so that
there is cold air circulation
Wrap the food correctly.
Refer to "Closing the
door".
Clean the door gaskets.
If necessary, adjust the door. Refer
to "Installation".
If necessary, replace the defective
door gaskets. Contact the Service
Center.
ENGLISH
23