Disposal; Technical Data; Troubleshooting - Beurer Janosch JBY 52 Gebrauchsanweisung

9

disposal

In the interests of environmental protection, these devices must not be disposed of in the
household waste at the end of their service life. They should be disposed of at the appropriate
regional collection points.
Please observe local regulations when disposing of materials.
Dispose of the device in accordance with the EC directive on old electric and elec-
tronic devices 2002/96/ec – weee (Waste Electrical and Electronic Equipment).
If you have queries, contact the appropriate local authorities.
10

technical data

Operating voltage:
Power consumption:
Heating time:
Temperature for keeping warm:
11

troubleshooting

Fault
Water leaks from the bottom
of the device when in use.
The warming process does
not start or does not end.
No LED display
The baby food warmer does
not switch on once it is
plugged in.
The temperature on the
display does not increase
once the warming process is
started; the device switches
itself off after a while.
The food is not warm at the
end of the warming process.
220–240 V ~ / 50/60 Hz
80 watts
3 - 18 min.
35 °C - 85 °C
Cause
Device faulty
Thermostat broken
Mains plug not (correctly)
plugged in or device faulty
No electricity
No water in the device
Not enough water in the
device
Action
Switch off the device imme-
diately, unplug it, let the
water drain out and return the
device to the retailer.
Switch off the device imme-
diately, unplug it, let the
water drain out and return the
device to the retailer.
Check that the mains plug
is (correctly) plugged in. If
there is still no display, switch
off the device, unplug it and
return it to the retailer.
Check that the mains plug is
correctly plugged in.
Unplug the device, let it cool
down, then fill it with water
and start the warming proc-
ess as described in these
instructions.
Unplug the device, let it cool
down, then fill it with sufficient
water and start the warming
process as described in these
instructions.
13