Clearaudio TT2 Bedienungsanleitung Seite 7

User manual / Bedienungsanleitung
Tighten the screw of the tonearm base as shown in
picture 6.
Before the next step please first remove all counterweights
from the headshell.
Slide the headshell through the proper drilling in the carriage
of the tonearm.
When sliding the headshell, turn the headshell (as shown in
pic. 8) so that the positioning shaft of the headshell can pass
the main rod of the tonearm.
After passing the first main rod, turn the headshell back
(as shown in pic. 9)
Pic. 8: Turrning the headshell
Approx. 1.5 cm
(15 mm /
0.59 inch)
Made in Germany
Positioning shaft
Pic. 10: Correct position of the headshell
Pic. 6: Tighten the screw of the VTA-
assembly
Pic. 7: Setting up the headshell
Pic. 9: Turning the headshell back
Distance between
diamond tip
headshell locking
screw is apprrox.
62 mm / 2.44
inch
and
7