Adjustment Of The Azimuth (Vertical Needle-Position In The Groove) - Clearaudio TT2 Bedienungsanleitung

User manual / Bedienungsanleitung
If The carbon headshell tube should be parallel to the surface of the record (without needle protec-
tion and cartridge lifted down record!).
The tonearm angle can be adjusted with the screw in the tonearm base (see pic. 15 b).
The tonearm angle is correct adjusted, if the bubble level is centred.
Pic. 15 a: Bubble level
Adjust the correct stylus pressure as instructed in the cartridge´s user manual.
To achieve the exact stylus pressure we recommend the use of the clearaudio digital stylus pressure
gauge "Weight Watcher" (Art.-#: AC 094; also available at www.analogshop.de).

4.3 Adjustment of the azimuth (vertical needle-position in the groove)

Please be very careful by the following steps:
Lift your cartridge up (!)
Take a straight bar or rod (e.g. hex key wrench) which can be placed on the top of the cartridge.
Place this piece on top of the headshell as shown in the picture 16 and secure it with a piece of
adhesive tape.
a
a = b
Pic. 16: Adjustment of the azimuth
10
b
Pic. 15 b: Adjustment of the tonearm`s tilt angle
© clearaudio electronic GmbH, 2017/11