Tape transport test cassette MC-112C Part No. 72008-247.00 Head gauge 401 Part No. 72008-401.00 Kopflehre 401 Sach-Nr. 72008-401.00 Please note the Grundig Catalog “Test and Measuring Equipment” Beachten Sie bitte das GRUNDIG Meßtechnik-Programm, das Sie unter folgender Adresse erhalten: obtainable from:...
A defect is indicated in the display by the message "Erro" and the test mode is stopped. modus. Durch Ausschalten des Gerätes wird der Testmodus beendet. The Testmode is finished by switching off the unit. Notizen / Notes GRUNDIG Service 1 - 3...
Bedienhinweise Dieses Kapitel enthält Auszüge aus der Bedienungsanleitung. Weitergehende Informationen entnehmen Sie bitte der gerätespezifischen Bedienungsanleitung, deren Sachnummer Sie in der entsprechenden Ersatzteilliste finden. WIEDERGABE BEDIENELEMENTE ALLGEMEINES Auswahl der Kassettenseite Wiedergabe beider Kassettenseiten (Deck A oder B) RECORD/MUTE RECORD LEVEL DUBBING 9 AB B Ein- und Ausschalten •...
Operating Instructions This chapter contains excerpts from the operating instructions. For further particulars please refer to the appropriate user instructions the part number of which is indicated in the relevant spare parts list. GENERAL PLAYBACK OPERATING ELEMENTS Selecting the tape side Playback of both sides (deck A or B) Switching on and off •...
- 4 Plattenhalter D (Fig. 2) ausrasten und Leiterplatte herausnehmen. - Unhook the 4 board holders D (Fig. 2) and remove the circuit board. - Bei Bedarf Steckverbindungen abziehen. - Disconnect the plug-in connections if necessary. P513 P512 Fig. 2 Fig. 3 1 - 6 GRUNDIG Service...
Seite 7
- Undo the screw M (Figs. 6 and 7). - Bremse nach hinten herausnehmen. Achten Sie auf die Cassettendeckel-Drehfeder I (Fig. 6). - Take the brake out towards the rear. Take care of the cassette lid torsion springs I (Fig. 6). GRUNDIG Service 1 - 7...
Seite 8
3, the two washers 4 and the spring 5 (Fig. 12). Nach dem Einbau des Schwungrades muß die Capstanwelle mit After having fitted the new flywheel the capstan must be cleaned with Spiritus oder Reinigungsbenzin gereinigt werden. spirit or cleaning benzine. 1 - 8 GRUNDIG Service...
Seite 9
- Undo 2 screws U and remove the sound head (Fig. 16). (Fig. 16). - Kopfleitungen ablöten. - Unsolder the head leads. - Beim Einbau sind die Kopfleitungen wieder einzuhängen. - Attach the head leads when re-assembling. Deck B Deck A Fig. 16 GRUNDIG Service 1 - 9...
Seite 10
- Cassettentürführungen Z (Fig. 19) aushängen und die Tür vor- take it out carefully towards the rear. - Take care of the torsion spring I. sichtig nach hinten herausnehmen. - Achten Sie dabei auf die Drehfeder I. Fig. 19 1 - 10 GRUNDIG Service...
Gerätefunktion: High Dubbing NF-Voltmeter an Meßpunkt D3 (linker Kanal) bzw. an Mit F106 am Meßpunkt D3 (linker Kanal) und mit F105 am den Meßpunkt D4 (rechter Kanal). Meßpunkt D4 (rechter Kanal) HF-Minimum einstellen. Gerätefunktion: High Dubbing GRUNDIG Service 2 - 1...
Seite 12
= 500mV, f = 333Hz. Gerätefunktion: Wiedergabe ≈ 10 k Gerätefunktion: Aufnahme-Pause Dolby aus LINE IN Dolby aus Klirrfaktor bei Wiedergabe der gemachten Aufnahme: – ≤ 1,5% IEC I Aufnahme Start ≤ 2,0% IEC II K 2 - 2 GRUNDIG Service...
Seite 13
HX-PRO LOGIK-PLATTE LOGIC BOARD R 543 kurzschließen short-circuit (HIGH SPEED) R 547 T 523 DECK A DECK B R 558 NORMAL R 564 R 566 NORMAL HIGH R 561 HIGH P506 P505 BANDGESCHWINDIGKEIT TAPE SPEED GRUNDIG Service 2 - 3...
AF-voltmeter to test point D3 (left channel) and to test Adjust for minimum RF with F106 at test point D3 (left point D4 (right channel) respectively. channel) and F105 at test point D4 (right channel). Function: High Dubbing 2 - 4 GRUNDIG Service...
Seite 15
Function: Record-Pause LINE IN Dolby off Dolby off – Distortion factor measured at the LINE OUT sockets at Record-Start 47kΩ on playing back the made recording: ≤ 1.5% IEC I ≤ 2.0% IEC II K GRUNDIG Service 2 - 5...
(Azimut), siehe Seite 2 - 1. KOPFLEHRE 401 Kopflehre HEAD GAUGE 401 Head gauge SCHIEBER A SLIDER A FÜHLHEBEL B SENSING LEVER B Fig. 1 Deck B FÜHLHEBEL B SENSING LEVER B Fig. 2 2 - 6 GRUNDIG Service...
Näherungswerte, gemessen bei Wiedergabe ! The measured values given in the circuit diagram are approximates, measured at PLAY ! 4.5V -24V -24V 11.5V 11.5V 1.9V 0.7V 0.7V 0.7V PAGE 3-11 3 - 3 GRUNDIG Service 3 - 4 GRUNDIG Service...
Seite 19
SHIFT REGISTER BUFFER = NO CONNECT Vss = GROUND PAGE 3-11 Vcc = SUPPLY VOLTAGE PAGE 3-11 SDA = SERIAL DATA MEMORY ARRAY SCL = SERIAL CLOCK X 24 COO GRUNDIG Service 3 - 5 GRUNDIG Service 3 - 6...
11.6V 0.7V FROM R292 PAGE 3-11 0.3V 11.6V 2.6V 1.2V 0.6V 1.2V FROM LEVEL BOARD 0.5V PAGE 3-11 0.3V FROM R291 PAGE 3-11 11.6V 11.3V 0.7V 11.4V 10.6V 0.7V 11.3V 3 - 7 GRUNDIG Service 3 - 8 GRUNDIG Service...
Seite 21
11.6V 11.4V IC104 +...V (PLAY) 11.6V 0.4V 0.4V 0.4V 0.4V 1.3V 6.3V 0.6V 0.6V TO C231 PAGE 3-11 2.5V IC104 CXA1330S (DOLBY B/C) HDET LDET Mode Control HDET LDET IREF GRUNDIG Service 3 - 9 GRUNDIG Service 3 - 10...
Seite 22
DC-VOLTAGES MEASURED AGAINST MINUS TERMINAL (GND) ON PLAYBACK. BEI DEN IN DEN SCHALTPLÄNEN ANGEGEBENEN MESSWERTEN HANDELT ES THE MEASURED VALUES GIVEN IN THE CIRCUIT DIAGRAMS ARE APPROXIMATES! SICH UM NÄHERUNGSWERTE! 3 - 11 GRUNDIG Service 3 - 12 GRUNDIG Service...
Schaltpläne und Druckplattenabbildungen / Circuit Diagrams and Layout of PCBs Logic Board Audio Board Component side Component side Für die tatsächliche Bauteilebestückung ist das Schaltbild maßgebend. The circuit diagram is relevant for the actual component assembly. GRUNDIG Service 3 - 13 GRUNDIG Service 3 - 14...
DREHFEDER CASS. TUER TORSION SPRING CASS. DOOR 0037.000 75954-068.03 LICHTLEITER LIGHT GUIDE T 191-195 8303-207-548 TRANS BC548C 0038.000 75954-068.08 LOGO GRUNDIG LOGO GRUNDIG R 154 8792-002-159 ESTR.S6 47 KOHM LIN T 200 8303-207-548 TRANS BC548C 0039.000 8290-991-275 NETZKABEL KPL GWN9.17 WF MAINS CABLE CPL GWN9.17 S...
Ersatzteilliste List of spare parts LAUFWERK A CRF 477 SACH-NR. / PART NO.: 59726-004.00 POS. ABB. SACHNUMMER ANZ. DESCRIPTION BEZEICHNUNG POS. FIG. PART NUMBER QUA. 0001.000 75951-018.94 WIEDERGABEKOPF KPL. P/ HEAD 0002.000 72008-614.49 KOPFHALTER HEAD HOLDER 0003.000 72008-614.51 HEBEL LEVER 0004.000 72008-418.47 FEDER...
Seite 28
Ersatzteilliste List of spare parts LAUFWERK B CRF 478 SACH-NR. / PART NO.: 59726-005.00 POS. ABB. SACHNUMMER ANZ. DESCRIPTION BEZEICHNUNG POS. FIG. PART NUMBER QUA. 0001.000 72008-614.58 AW-KOPF KPL. R/P HEAD 0002.000 72008-614.49 KOPFHALTER HEAD HOLDER 0003.000 72008-614.51 HEBEL LEVER 0004.000 72008-418.47 FEDER...