Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation
• Cut the hose connector to the desired diameter and fasten this to the pump.
• Connect the pond hose to the hose connector using a hose clamp (not supplied).
• Install the pump in your pond at least 20 cm below the surface of the water. Make sure
that the pump is seated firmly.
• When used inline, outside of the pond; make sure the pump gets enough water supply
and does not run dry, make sure all connections are 100% waterproof, leakage may lead
to an empty pond and cause harm to your fish and plants.
• Never lift the pump out of the water by pulling the power cord.
Usage of Remote Control
This Remote Control is dedicated to
the SuperFish PondECO Plus RC
10000 and E 10000 pumps.
When used on a different type of
pump, the pump will not work
(correctly).
See picture above for a proper
installation of the receiver.
With the Remote Control the pump
can be set to the desired water flow
level and jet. When you reduce the
flow you will also reduce the power
consumption.
Make sure the Remote Control does
not get wet and store it in a dry place
Maintenance
• Remove the pump from your pond during frosty periods and clean it well and store it in
a dry place free from frost.
• Your pump needs regular cleaning, see page 10, there is no warranty on failures due to
dirty pumps and scale build up inside the pump caused by improper maintenance.
• Depending on usage the rotor of your pump can get worn out and damaged, this is
normal, new rotors can be purchased at your dealer.
• Damage of cable, rotor or other parts due to wrong usage, is not covered by warranty!
Step
Flow
Pump capacity
1
4,500 l/h
2
5,000 l/h
3
5,700 l/h
4
6,200 l/h
5
6,800 l/h
6
7,300 l/h
7
7,700 l/h
8
8,100 l/h
9
8,400 l/h
10
9,200 l/h
H. max
Power
Head of water
1.6 m
13 Watt
2.1 m
17 Watt
2.7 m
23 Watt
3.2 m
30 Watt
3.8 m
38 Watt
4.4 m
45 Watt
5.0 m
53 Watt
5.4 m
59 Watt
5.7 m
64 Watt
5.8 m
68 Watt
3
Werbung
