Adjusting Setup Items - Sony CDX-GT564UI Bedienungsanleitung

Adjusting setup items

1
Press and hold the select button.
The setup display appears.
2
Rotate the control dial until the desired
item appears, then press it.
3
Rotate the control dial to select the
setting, then press it.*
The setting is complete.
4
Press (BACK).
* For CLOCK-ADJ and BTM settings, step 4 is
not necessary.
The following items can be set depending
on the source and setting:
CLOCK-ADJ (Clock Adjust) (page 4)
CT (Clock Time)
Activates the CT function: "ON," "OFF"
(page 8).
BEEP
Activates the beep sound: "ON," "OFF."
CAUT ALM* (Caution Alarm)
1
Activates the caution alarm: "ON,"
"OFF" (page 4).
AUX-A* (AUX Audio)
1
Activates the AUX source display: "ON,"
"OFF" (page 18).
AUTO OFF
Shuts off automatically after a desired
time when the unit is turned off: "NO,"
"30S (Seconds)," "30M (Minutes)," "60M
(Minutes)."
REAR/SUB*
1
Switches the audio output: "SUB-OUT"
(subwoofer), "REAR-OUT" (power
amplifier).
DEMO (Demonstration)
Activates the demonstration: "ON,"
"OFF."
DIMMER
Changes the display brightness: "ON,"
"OFF."
M.DISPLAY (Motion Display)
– "SA": to show moving patterns and
spectrum analyzer.
– "OFF": to deactivate the Motion Display.
AUTO SCR (Auto Scroll)
Scrolls long items automatically: "ON,"
"OFF."
REGIONAL*
2
Restricts reception to a specific region:
"ON," "OFF" (page 8).
ZAP TIME (Zappin Time)
Selects the playback time for the
ZAPPIN function.
– "Z.TIME-1 (about 6 seconds),"
"Z.TIME-2 (about 15 seconds),"
"Z.TIME-3 (about 30 seconds)."
ZAP BEEP (Zappin Beep)
Has the beep sound between track
passages: "ON," "OFF."
LPF FREQ* (Low Pass Filter Frequency)
3
Selects the subwoofer cut-off frequency:
"50Hz," "60Hz," "80Hz," "100Hz,"
"120Hz."
LPF SLOP* (Low Pass Filter Slope)
3
Selects the LPF slope: "1," "2," "3."
SW PHASE* (Subwoofer Phase)
4
Selects the subwoofer phase: "NORM,"
"REV."
HPF FREQ (High Pass Filter Frequency)
Selects the front/rear speaker cut-off
frequency: "OFF," "50Hz," "60Hz,"
"80Hz," "100Hz," "120Hz."
HPF SLOP (High Pass Filter Slope)
Selects the HPF slope (effective only
when HPF FREQ is set to other than
"OFF"): "1," "2," "3."
17