Bluetooth ® Pairing - Hama 00177080 Bedienungsanleitung

• It takes around 2-3 hours until the battery is completely charged.
• Once the charging process is complete, the red light of the LED
(3) turns to blue light.
• Disconnect all cable and mains connections used to charge the
device.
4.2. Wearing option: 3.5 mm stereo jack cable
• Connect the earphones (1) to the 3.5 mm stereo jack cable (9).
(See Drawing C)
• Make sure to always connect the left earphone to the left cable
connection and the right earphone to the right cable connection.
(See Drawing B)
• Use the 3.5 mm stereo jack (10) to connect the headset to your
terminal device.
• In this case you do not need to charge the earphones.
5. Operation
Switching the headset off/on
• Press the MF button (5) until a voice says "Power ON" and the
blue LED flashes.
• To switch it off, press and hold the MF button (5) until a voice
says "Power OFF" and the red LED flashes.
5.1. Bluetooth pairing
®
Note
The functions described in this section only work with terminal
devices that support Bluetooth
worn as a Bluetooth stereo headset (see section 4.1).
®
Note – Pairing
• Make sure that your Bluetooth
on and Bluetooth is activated.
®
• Make sure that your Bluetooth
visible for other Bluetooth
• For more information, please refer to the operating
instructions of your terminal device.
• The headset and the terminal device should not be any further
than 1 metre away from each other. The smaller the distance,
the better.
• Switch the headset on using the MF button (5).
• Press and hold the MF button (5) until the red and blue LEDs
flash alternatingly. The headset is searching for a Bluetooth
connection.
• Open the Bluetooth settings on your terminal device and wait
®
until Hybrid BT appears in the list of Bluetooth
and only when the product is
®
-capable terminal device is
®
-capable terminal device is
®
devices.
®
devices found.
®
• Select Hybrid BT and wait until the headset is listed as
connected in the Bluetooth
Note – Bluetooth
Some terminal devices require a password in order to connect
to another Bluetooth
• If your terminal device requests a password for connection
with the headset, enter 0000.
Note
• Once the connection has been established, a voice says,
"Connected".
• If the connection attempt takes longer than 300 seconds to
complete, it is cancelled and the LEDs go out. In this case,
repeat the steps listed previously under 5.1 Bluetooth
pairing.
5.2. Automatic Bluetooth
pairing)
Note
• Make sure that your Bluetooth
on and Bluetooth
• Make sure that your Bluetooth
visible for other Bluetooth
• For more information, please refer to the operating
instructions of your terminal device.
• Switch the headset on using the MF button (5). The blue LED
begins to flash and the headset automatically connects with the
last terminal device used.
• Upon successful connection, a voice says, "Connected".
Note
• Once the connection has been established, a voice says,
"Connected".
• If the connection attempt takes longer than 300 seconds to
complete, it is cancelled and the LEDs go out. In this case,
repeat the steps listed previously under 5.2.
• It may be necessary to make settings on your terminal device
®
to enable automatic connection with the paired headset.
settings on your terminal device.
®
password
®
device.
®
connection (after successful
®
-capable terminal device is
®
is activated.
®
-capable terminal device is
®
devices.
®
®
3