Palmer PMC1 MONICON Bedienungsanleitung Seite 9

CONNECtION
dIrECt CONNECtION OF A NOtEBOOk/COMputEr
note: BeFore ConneCtion, MaKe Certain tHat yoUr Monitors are tUrneD oFF so tHat no loUD
noises (PoPs) oCCUr WHen tHe PlUgs are inserteD.
Computer / sound source
XLR / m
3.5 mm Stereo
XLR / f
if you want to use the usual headphone output, you will need a 3.5 mm mini-trs to mini-trs stereo cable.
Connect one end to the headphone output and the other to the 3.5 mm trs input of the Monicon.
• Connect the output of the Monicon to your monitors.
• set the output volume of your computer to maximum.
• turn the volume control of the Monicon to full attenuation (all the way to the left).
• now turn on your monitors.
• Make certain that the mute function of the Monicon is deactivated and slowly turn up the volume control of
the Monicon.
note: iF tHe Control range is too great or tHe oUtPUt level is too loUD, tUrn DoWn tHe
volUMe oF yoUr Monitors. For an iDeal signal-to-noise ratio, tHe volUMe oF tHe CoMPUter
sHoUlD alWays Be set to MaXiMUM.
9