Daily Use; The Heat Setting; Automatic Heat Up - AEG HK855200XB Benutzerinformation

26 www.aeg.com
3.4 OptiHeat Control (3 step
Residual heat indicator)

4. DAILY USE

4.1 Activating and
deactivating
Touch
deactivate the hob.
4.2 Automatic Switch Off
The function deactivates the hob
automatically if:
• all cooking zones are deactivated,
• you do not set the heat setting after
you activate the hob,
• you spill something or put something
on the control panel for more than 10
seconds (a pan, a cloth, etc.). An
acoustic signal sounds and the hob
deactivates. Remove the object or
clean the control panel.
• the hob gets too hot (e.g. when a
saucepan boils dry). Let the cooking
zone cool down before you use the
hob again.
• you use incorrect cookware. The
symbol
zone deactivates automatically after 2
minutes.
• you do not deactivate a cooking zone
or change the heat setting. After
some time
deactivates.
The relation between the heat setting
and the time after which the hob
deactivates:
, 1 — 3 — 6 hours
•
• 4 — 7 — 5 hours
• 8 — 9 — 4 hours
• 10 — 14 — 1.5 hours
WARNING!
/ / There is a risk of
burns from residual heat.
The indicator shows the level
of the residual heat.
WARNING!
Refer to Safety chapters.
for 1 second to activate or
comes on and the cooking
comes on and the hob
The induction cooking zones make the
heat necessary for cooking process
directly in the bottom of the cookware.
The glass ceramic is heated by the heat
of the cookware.

4.3 The heat setting

To set or change the heat setting:
Touch the control bar at the correct heat
setting or move your finger along the
control bar until you reach the correct
heat setting.
4.4 Cooking zone indication
min.
The horizontal line shows the size of the
cooking zone. The break in the horizontal
line shows the minimum cookware
diameter.
Refer to "Technical information" chapter.

4.5 Automatic Heat Up

If you activate this function you can get a
necessary heat setting in a shorter time.
The function sets the highest heat setting
for some time and then decreases to the
correct heat setting.
To activate the function the
cooking zone must be cold.