To install the Homematic wireless infrared motion
detector outdoor, proceed as follows:
•
Position the wall mount (F) with the plane
surface upwards at a suitable point (see Section
7.1) on a wall or ceiling.
•
Mark through the screw holes where you will
make the corresponding bore holes in the wall
mount (F).
•
Drill holes 5 mm diameter and 35 mm deep.
Insert the plugs (included in the scope of supply).
•
For ceiling mounting, drill through the preformed
holes in the wall mount (F) with a 3.2 mm drill.
•
Place the wall mount (F) over the holes. Use the
screws supplied to attach the mount to the wall.
•
Then push the Homematic wireless infrared
motion detector outdoor back into the wall mount
(F) until it locks. Insert the device into the desi-
gnated opening (1) from the front first and then
lock it in place at the back (2):
42