Insert With 2-Phase 'Central Control - Berker RolloTec Bedienungsanleitung

Connection of RolloTec
Example B for 2 louver motors:
Inserts
The automatic and manual control of motors M1 and M2 is effected after the individual
programming of RolloTec
Via insert
commands depending on the programming of insert
(e. g. a central DOWN command in the evenings for all louver motors connected).
As shown in the wiring diagram, further inserts can be added.
Observe the connected loads of the automatic cut-outs.
Important: As long as an UP command is applied to extension input '2' the louver
cannot be actuated manually or automatically on the unit itself.
32
® Insert with 'central control'.
, and with RolloTec ® timer.
® timer and (e. g. sun protection function).
with the RolloTec ® timer, the 'central' control is handled. Switching
are executed for both motors
Connection of RolloTec ® Insert with 2-phases 'central control'.
The connection to two phases facilitates the installation of the central control system
within a different storey or room.
Example for 2 louver motors:
Inserts , and with RolloTec ® pushbutton or RolloTec
Insert with RolloTec ® timer.
Motors M1 (insert ) and M2 (insert ) are operated manually by a RolloTec
®
button or a RolloTec radio control pushbutton. Both motors are actuated through
insert at the same time.
In addition, the automatic and manual control of both motors is effected 'centrally'
through insert with RolloTec ® timer. The switching commands are evaluated for both
motors in the same way. Simultaneous moving up or down of the motors connected is
facilitated (e. g. a central UP command in the mornings and a central DOWN command
in the evenings for all louver motors connected).
As shown in the wiring diagram, further inserts can be added.
Observe the connected loads of the automatic cut-outs.
Important: As long as an UP command is applied to extension input '2' the louver
cannot be actuated manually or automatically on the unit itself.
® radio control pushbutton.
® push-
33