Warranty - T.I.P. SPF 180 Gebrauchsanweisung

M
3. The pump stops after a
ALFUNCTION
short time of operation be-
cause the thermal motor pro-
tection feature has triggered.
4. Low current
5. Noise in the pump during
the operation

11. Warranty

The present device was manufactured and inspected according to the latest methods. The seller war-
rants for faultless material and workmanship in accordance with the legal regulations of the country in
which the device was purchased. The warranty period begins with the day of the purchase and is sub-
ject to the provisions below:
Within the period of warranty, all defects which are to be attributable to defective materials or manu-
facturing will be eliminated free of charge. Any complaints are to be reported immediately upon their
detection.
The warranty claim becomes void in the case of interventions undertaken by the purchaser or by third
parties. Damage resulting from improper handling or operation, incorrect setting-up or storage, inap-
propriate connection or installation or Acts of God or other external influences are excluded from war-
ranty.
Parts being subject to wear and tear are excluded from warranty.
All parts were manufactured using maximum care and high-quality materials and are designed for a
long lifecycle. It should be understood, however, that the wear and tear depends on the kind of use,
the intensity of use and the internals of maintenance. Complying with the installation and maintenance
information contained in the present operating instructions will therefore considerably contribute to a
long lifecycle of these wearing parts.
In case of complaints, we reserve the option of repairing or replacing the defective parts or replace the
entire device. Replaced parts will pass into our property.
Claims for liquidated damages are excluded unless they are caused by willful acts or negligence on
the side of the manufacturer.
The warranty does not provide for any claims beyond those referred to above. The warranty claim has
to be evidenced by the purchaser in the form of the submission of the sales receipt. The present war-
ranty commitment is valid in the country in which the device was purchased.
25
P C
1. The electrical supply does not cor-
OSSIBLE AUSE
respond to the information given on
the type plate
2. Pump or intake openings are
blocked by solids.
3. Temperature of the liquid is too
high.
4. Pump is running dry.
1. Dirty filter
2. Dirt in filter basket of sand filter
3. Blockage in the pipe
1. Defect bearing
2. Air penetrates into the intake line.
3. Blockage during aspiration
4. Fault in the impeller
5. Disturbance while sucking
1. Please use a device complying with GS
(German technical supervisory authority) to
check for the presence of voltage (safety in-
formation to be observed!).
2. Remove possible congestion.
3. Make sure that the temperature of the liq-
uid being pumped does not exceed the max.
admissible value.
4. Eliminate causes of dry-running.
1. Rinse or clean the filter
2. Clean the filter basket of the tube
3. Check the pipes. Avoid any bending of
hoses. Flush with sufficient water in case of
need.
1. Contact your local service partner or the
manufacturer
2. see section 2 of this table
3. Check and clean the suction hose
4. Contact your local service partner or the
manufacturer
5. Improve the suction inlet. Make sure the
suction inlet is under the water level of the
swimming pool. Reduce the numbers of
screws; assemble a pipe with a larger diam-
eter.
10
E
LIMINATION