Fitting The Sensors - Carson SON Reflex Wheel Pro 2 Telemetry 500500038 Betriebsanleitung

Fitting the sensors

The "REFLEX WHEEL PRO2 telemetry" kit is supplied
with three sensors:
1 x speed sensor (rpm)
GB
The speed sensor can be used
for ascertaining the rpm of the
engine or drive shaft.
The sensors must be mounted on the vehicle using
the fittings supplied.
Fitting the temperature sensor (C°)
The two temperature sensors are attached to the
engine housing and heat sink on the ESC using a
piece of sticky tape. The sensors should have direct
contact.
Example of fitting the speed sensor
(rpm)
You will achieve the best results if you stick the rev
speed sensor close to a drive shaft. You should then
affix the sticker for sensor identification as shown in
the adjacent picture. The distance from the speed
sensor to the sticker must be no less than 1cm.
30 CARSON Reflex Wheel Pro 2 Telemetry 500500038
Speed sensor (Rpm)
Temperature probe for
engine
2 x temperature sensors
Two separate temperature sensors are used for
ascertaining the operating temperature of the
ESC and the engine.
Temperature probe
for ESC
ESC