Control Panel - IKEA HD R40 B Betriebshandbuch

PRODUCT SHEET

1. Control panel.

2. Grease filter
3. Light
4. Panel
Bulb maintenance
1. Disconnect the hood from the power supply.
2. Use a small screwdriver or another suitable tool to prise
and remove the lighting unit (Fig. 1).
3. Replace the damaged lamp.
4. Only use 20 W max. - G4 halogen lamps, taking care not
to touch them with hands.
5. Close the lighting unit (snap-on).
Grease filters:
The metal grease filter has an unlimited life and must be
washed once a month by hand or in a dishwasher at a low
temperature and with short cycle. Washing in a dishwasher
can cause the grease filter to become opaque, but its filtering
capacity is not affected.
Grease filter maintenance:
1. Disconnect the electrical power supply.
2. Open the panel.
3. Remove the grease filter/s (Fig. 2); to do so, pull the
spring release handle (f1) then remove the filter/s (f2).
Carbon filter maintenance
(for models with filter installation)
The carbon filter must be washed once a month in a
dishwasher at the highest temperature, using a normal
dishwasher detergent. It is advisable to wash the filters
separately.
After washing, reactivate the carbon filter by drying it in the
oven at 100° C for 10 minutes.
Change carbon filter every 3 years
Fitting the carbon filter:
1. Open the panel and remove the grease filter (Fig. 2).
2. Install the carbon filter behind the grease filter and fasten
with two fixing elements (Fig. 3).
To remove the filter, proceed in reverse order.
5019 618 33119/A
:
GB
D
CONTROL PANEL
ON/OFF Light switch
Extraction and minimum extraction speed
ON/OFF switch.
Extraction and medium extraction speed
+
ON/OFF switch.
Extraction and maximum extraction speed
+
ON/OFF switch.
.
F I
Fig. 1
Fig. 2
Fig. 3
LI3KHA