VEGA VEGAFLEX 65 Betriebsanleitung Seite 48

10 Anhang
secondary_value_2
l
This is the distance value (sensor_value) with the status of the transducer block
-
It is the input for the AIFB when CHANNEL = 3 is selected
-
The unit is defined in "secondary_value_2"
-
secondary_value_2_unit
l
Selected unit code for "secondary_value_2"
-
sensor_value
l
This is the distance value of the sensor
-
The unit is defined in "sensor_range.Units Index"
-
sensor_range
l
"sensor_range.Units Index" is the unit for "sensor_value", "max/min_peak_sensor_value",
-
"Calibration Highest/Lowest Point" and "empty_vessel_ocrr_dist"
simulate_primary_value
l
simulate_secondary_value_1
l
simulate_secondary_value_2
l
Linearization Type
l
Linearization Type, the selectable types are: Linear, User def; Cylindric lying container, Spherical
-
container
tab_op_code
l
tab_index
l
tab_max_number
l
tag_min_number
l
tab_actual_number
l
tab_status
l
tab_x_y_value
l
display_source_selector
l
Selects the type of value, which is displayed on the indicating and adjustment module
-
max_peak_sensor_value
l
Holds the maximum "sensor_value". The unit is defined in "sensor_range.Units Index"
-
min_peak_sensor_value
l
Holds the minimum "sensor_value". The unit is defined in "sensor_range.Units Index"
-
Calibration Highest Point
l
Min./Max. adjustment: this is the upper calibrated point of the sensor_value. It refers to
-
"cal_level_hi"
The unit is defined in "sensor_range.Units Index"
-
Calibration Lowest Point
l
Min./Max. adjustment: this is the lower calibrated point of the sensor_value. It refers to
-
"cal_level_lo"
The unit is defined in "sensor_range.Units Index"
-
cal_level_hi
l
Min./Max. adjustment: this is the value of level at "Calibration Highest Point". The unit is
-
defined in "level_unit
When writing "cal_level_hi" and "cal_type" = 1, the "Calibration Highest Point" is automatically set
-
to "sensor_value"
cal_level_lo
l
48
VEGAFLEX 65 • Foundation Fieldbus