Hotpoint Ariston li 460 Bedienungsanleitung Seite 18

1. Turn the water tap on.
2. Open the door and press the ON/OFF button: the indicator
light will illuminate.
3. Measure out the detergent (see below).
4. Load the racks (see Loading the racks).
5. Select the programme by pressing the WASH CYCLE
SELECT button; the corresponding indicator light will illuminate.
6. Select the wash options (see below).
7. Start the wash cycle by shutting the door: the machine will
emit a confirmation beep.
8. At the end of the cycle two short beeps will sound and the
WASH CYCLE indicator light will flash. Open the door, switch
off the appliance by pressing the ON/OFF button, shut off the
water tap and unplug the appliance from the electricity socket.
9. Wait for a few minutes before removing the crockery, in
order to avoid burns. Unload the racks, beginning with the
lower level.
If a mistake was made during the wash cycle selection
process it is possible to change the cycle, provided that it has
only just begun: open the door, taking care to avoid the
escaping steam, and press the WASH CYCLE SELECT
button, holding it for 4 seconds. After one long beep and three
short beeps, the WASH CYCLE indicator light will switch off:
select the new wash cycle and start the programme by
shutting the door.
Open the door, taking care to avoid the escaping steam, and
place the crockery inside the dishwasher. Close the door: the
cycle starts from the point at which it was interrupted.
If the door is opened during the wash cycle, or if there is a
power cut, the cycle stops. It starts again from the point at
which it was interrupted once the door has been shut or the
electricity supply is restored.
A successful wash also depends on the correct amount of
detergent being used, as recommended by the manufacturer.
Exceeding the recommended amount does not result in a
more effective wash and pollutes the environment.
compartment A: Washing detergent compartment A compartment A compartment A compartment A
compartment B: Pre-wash detergent compartment B compartment B
compartment B compartment B
1. Open cover C by pressing button
D
D.
A
B
2. Pour in the detergent after
consulting the Wash cycle table :
• for powder detergent use
compartments A and B
• for tablets, when the cycle
requires 1 tablet, place it in
compartment A and close the cover;
C
when it requires 2, place the second
tablet at the bottom of the appliance.
3. Remove detergent residues from the edges of the
compartment and close the cover until it clicks.
* Only available in selected models.