Maintenance; Grease Filters; Active Carbon Filter - Bauknecht DBR 5890 IN Benutzerhandbuch

MAINTENANCE

CAUTION:

GREASE FILTERS

Metal grease filters have an unlimited life and should be washed once a month either by hand or in a
dishwasher at a low temperature and with a short cycle. Washing in a dishwasher can cause grease filters
to turn white, but this in no way affects efficiency.
Pull out the handle to remove the filter.
Wash the filter and leave it to dry, proceeding in reverse order to refit it.
REPLACING THE HALOGEN BULBS
IMPORTANT: Replace using 10W max G4 halogen bulbs only.
1. Disconnect the hood from the mains power supply.
2. Use a small screwdriver to gently prise (at the three points indicated) the lamp cover off.
3. Remove the burnt-out lamp and fit a new one.
4. Replace the lamp cover so that it clicks into position.

ACTIVE CARBON FILTER

(filter hoods only):
The carbon filter must be cleaned once a month in a dishwasher at the highest temperature,
using a normal dishwasher detergent. Wash the filters on their own.
After washing, reactivate the carbon filter by drying it in the oven at 100°C for 10 minutes.
Change the carbon filter every 3 years.
Fitting the carbon filter:
1. Remove the grease filter.
2. Turn the side knobs 90° and then remove the filter holder "g".
3. Fit the carbon filter "i" in the filter holder "h".
Reverse the above procedure to refit the filter holder and grease filter.
- use protective gloves.
- disconnect the appliance from the mains power supply.
GB11