Connecting To The Mains / Switching On And To Standby - Philips MCP9350i/23 Anleitung

Connecting to the mains / Switching ON and to standby

Connecting to the mains
After connecting all desired equipment as described, you
can connect the Media Center to a wall socket.
1 Make sure all connections have been made before con-
necting the Media Center to the mains supply.
2 First connect the mains lead to the AC-INPUT (10) and
then to a wall socket.
> The Standby/On indicator (on the STANDBY-ON key 1)
lights up orange.
> The Media Center is now in low power mode, consuming
only a minimum amount of power.
Switching ON
• To switch on the Media Center from low-power mode,
press the y STANDBY-ON key (1) on the front of
the Media Center.
> The Standby/On indicator (1) goes out.
• Press the y STANDBY-ON key (1) again to put the
Media Center back to low-power mode.
Switching to standby
•
When the Media Center is switched on (Standby/On
indicator out), press the y Standby key (1) on the
remote control to place the Media Center in standby
mode.
> The Standby/On indicator (1) lights up red.
•
To switch the Media Center on again from standby
mode, press the y Standby key (1) on the remote
control again or the y STANDBY-ON key (1) on the
front of the Media Center.
> The Standby/On indicator (1) goes out.
Note: In both low-power and standby mode the Media Center is
still consuming some power.To disconnect the Media
Center from the mains supply completely, disconnect the
mains lead from the wall socket.
49