tepro PASADENA Bedienungsanleitung Seite 15

– Never use combustible fluids such gas-
oline or spirits.
– Do not put any charcoal pieces soaked
in flammable liquids on the embers.
Danger Risk of poisoning!
When burning charcoal, BBQ
briquettes, etc., carbon mon-
oxide is produced. This gas is
odorless and can be deadly in
closed rooms!
– Use the grill outdoors only!
Danger Health hazard!!
Do not use any paint solvents or
thinners to remove stains. Such
liquids are hazardous to health
and may not come into contact
with food.
Danger Hazards for children!
Children may become entan-
gled in packaging foil and suf-
focate.
– Never let children play with packaging
material.
– Make sure that children do not place
any small assembly parts in their
mouth. They could swallow small parts
and suffocate.
Danger Risk of injury!
Both the grill and individual
parts have some sharp edges.
– Be careful with individual parts to pre-
vent accidents and/or injury during as-
sembly and use. Wear protective hand
wear if necessary.
– Do not set up the grill near entryways
or heavily trafficked zones.
– Always exercise extreme caution while
grilling. You could lose control of the
product if you are distracted.
P170002_TEPRO_1030_Pasadena_DE_GB.indb 15
– Always be attentive and aware of what
you are doing. Do not use the product
when you are lacking in concentration
or are tired and/or under the influence of
drugs, alcohol or medication. One mo-
ment of inattention while using the prod-
uct is enough to lead to severe injury.
Attention Risk of damage!!
During use, the screws can
loosen slowly and impair the
grill's stability.
– Check that all screws are tightened be-
fore use. If necessary, tighten all screws
to guarantee stability.
Attention Risk of damage!!
Do not use any strong or abra-
sive solvents or scouring pads
as such products attack the
grill's surfaces and leave per-
manent markings.
Assembly
Preparation
Danger Risk of injury!
Failure to follow these instruc-
tions can lead to problems and
risks while using the grill.
1. Follow each assembly step described
here. First, read the assembly instruc-
tions thoroughly.
2. Allow yourself enough time for as-
sembly and find an even working
space of two to three square meters.
3. Small parts such as handles may be
preassembled.
t
15
16/1/17 10:43 AM