Amica EGSP 14685 E Bedienungsanleitung Seite 49

PREPARE THE APPLIANCE FOR OPERATION PREPARE THE APPLIANCE FOR OPERATION
Stop using multi-component detergents
• Add special salt and rinse aid to dispensers.
• Set the water hardness to the highest level (6)
and run an empty dishwasher.
• Adjust the water hardness.
• Adjust rinse aid setting.
Add rinse aid to the dispenser and adjust set-
ting
Use rinse aid to prevent the formation of white
water drops, lime scale spots, white streaks that
may occur on the dishes, as well as to improve
the drying process. Contrary to popular belief, it
not only serves to obtain a shiny dishes, but also
to facilitate drying. For this reason, make sure
there is always sufficient amount of rinse aid in the
dispenser.
If the rinse aid indicator on the control panel lights
up, add rinse aid to the dispenser.
To add rinse aid remove the dispenser lid by
unscrewing it (1). Add rinse aid until the level indi-
cator becomes dark. (4) Replace the lid and turn
it until markings align. Use rinse aid level indicator
to make sure the level is sufficient. Dark colour (4)
indicates sufficient rinse aid level in the dispenser,
and the light colour (4) indicates you need to add
rinse aid to the dispenser.
You can adjust rinse aid dosage from 1 to 6. The
factory setting for the rinse aid is 4. Adjust to a
higher dose if streaks remain on the dishes after
drying or to a lower dose if blue residue collets on
the dishes.
4
Rinse-Aid indicator
Full
¾ full
½ full
¼ full (add more)
Empty
Warning: Use only rinse aid designed for
domestic dishwashers. Wipe up spilled
rinse aid with a cloth as it will cause the
formation of large amounts of foam, and
thus will reduce the dishwashing effective-
ness.
13