Contrast Setting - eQ-3 WFC 310 Bedienungsanleitung

note!
For regions 60 – 89, the forecast is limited to 2 days. Both
fields for the following days (the far right on the display) and
the fields for the MIN-temperature (LO) remain empty.
The data is synchronized again after changing the region. The
reception of the new weather data requires at least 24 hours.
Setting the time zone
• From the start of the configuration, press the <SET> button
again for the time zone setting mode. The text "ti" is shown
on the display. The currently defined time zone is shown
directly to the right. Use the <+> button to select the desired
time zone.
note!
The time received from the radio-time signal generator
DCF or HBG is Central European Time (CET, CEST).
Setting the time zone is therefore only required for
other time zones (e.g. in Portugal or Great Britain).

Contrast setting

• From the start of the configuration, press the <SET> button
twice for the display contrast setting mode. The text "con"
appears. The currently set value is displayed in the field on
the right. The contrast can be set within a range from 1 to
16 using the <+> button.
• Pressing the <SET> button again ends configuration
mode.
Reception test
• Press the <+> button for at least 3 seconds to activate the
test for the reception of weather data. The text "test" is
shown on the display. The reception indicator for the weather
data shows the quality of reception. The reception is good
if the indicator is shown, otherwise a new location must be
found for installing the weather station.
• The reception test is either ended after approx. 1 minute
automatically or by actuating the <+> button.