EMAG HC-Serie Bedienungsanleitung Seite 9

Setting the Temperature (optional at HC-Series, D-Series and H-Series)
When power is on, LED actual uid temperature display window lamp ashes and displays uid's actual
temperature. To set related gears, rotate heating knob. In order to heat the cleaning uid during cleaning,
so long as the heating switch is rotated clockwise, then it will enter into the heating state.
The heating temperature can be selected and set freely according to the indication at the edge of rotary
switch on the panel. Once the green heating working indicator lamp is on, the heating band PTC will also
start working and heating the uid. When the temperature reaches the set temperature, the green heating
working indicator lamp will go o and the heating band PTC will stop working. When the uid temperature
is lower than the set temoerature, the heating band PTC will also start working and heating the uid. Then,
the temperature of the uid will be automatically controlled at the set temperature.
To stop heating, please rotate heating switch back to the „OFF" position anticlockwise.
Important: Heating function is not restriced by the ultrasonic cleaning timing but can work for a long time (however,it
is necessary to make sure there is enough water inside the slot).
Setting the timer
When power is on, rotate timing knob to set relevant gears. At this time, once „ON/OFF" button is pressed,
the ultrasonic cleaning function will start imediatley. Then the LED window lamp ashes and displays the
remaining time. When cleaning time is due, ultrasonic will stop and LED remaining time display window
ashes and resumes to ash in the position before setting. At this time, as long as „ON/OFF" button is pres-
sed, cleaning will start again. This is the so-called "memory function". It is convenient to use.
Ultrasonic function
After pressing „ON/OFF" button each time, the machine will initiate Ultrasonic function and the ultrasonic
will stop outputting. Press the button again to operate continuously after observing the cleaning e ect.
Degasing function (optional at D-Series)
At the normal working state, once degas button is pressed, the machine will start degasing function and
degas button indicator lamp will be on. Once degas button is pressed again, degassing function will stop
and degasing Button indcatorl lamp will be o .
Sweep function (optional at D-Series)
At the normal work state, sweep function will start and sweep button indicator lamp will be on once sweep
button is pressed. If sweep button is pressed again, the machin will stop sweep function and sweep button
Indicator lamp will be o .
Important: Sweep and degasing function do not work at once!
Emptying the tank
Remove waste Iiquids to empty the tank after no more need to use. Some models feature drain tap located
on the side of the unit, using it can make the removal of the waste liquids e ortless and safe. Always ensure
the drain tap is "Closed" when lling the tank with water.
9