Washing Programmes - Zanussi ZWG 7160 AP Benutzerhandbuch

Door light
10
At the end of the programme
The appliance stops automatically. The pilot light of the
button 9 and the pilot light 10 go off. The display shows
.
If a programme or an option that ends with water left in the
tub has been selected, the pilot light 10 remains on and
the door is locked to indicate that the water must be emp-
tied out before opening the door.
Follow the below instructions to empty out the water:
• Turn the programme selector dial to
• Select the draining or spinning programme.
• Reduce the spin speed if needed, by pressing the rele-
vant button.
• Press the button 9.
At the end of the programme, the door can be now
opened. Turn the programme selector dial to
the appliance off.
Remove the laundry from the drum and carefully check
that the drum is empty. If you do not intend to carry out
another wash, close the water tap. Leave the door open to
prevent the formation of mildew and unpleasant smells.
Warning! If there are children or pets in the house,
activate the child safety device in the inner side of

Washing programmes

Programme - Maximum and Minimum Temperature - Cycle De-
scription - Maximum Spin Speed - Maximum Fabrics Load - Type
of Laundry
COTTONS
(Katoen/Coton)
90°- Cold
Main wash - Rinses - Maximum spin speed: 1600 rpm
Max. load 6 kg - Reduced load 3 kg
White, coloured cotton and linen. Normally soiled items.
18
The pilot light 10 illuminates when the programme starts and indicates if the
door can be opened:
• light on: the door cannot be opened. The appliance is working or has
stopped with water left in the tub.
• light off: the door can be opened. The programme is finished or the water
has been emptied out.
• light blinking: the door is opening in a few minutes.
the door frame (for more details read " Child safety" in the
chapter "Safety Information").
Stand by : during programme setting up and once the pro-
gramme has finished, if the programme selector dial and
any button are not touched, after a few minutes the energy
saving system is enabled. The pilot lights and the display
go off. The green pilot light of the button 9 flashes with a
low frequency. By pressing any button the appliance will
come out of the energy saving status.
.
Door seal
to switch
At the end of every cycle,
check from the door seal
and remove objects that
could be trapped in the
fold.
Options
SPIN REDUCTION
RINSE HOLD
1)
SUPER QUICK
EXTRA RINSE
DELAY START
Detergent Com-
partment