Troubleshooting Guide - Blade RTF Bedienungsanleitung

Troubleshooting Guide

Problem
Helicopter will not
initialize
Helicopter will not spool up
Motor power decreases
during flight
Cannot turn off throttle hold
Powers off when flying
upside down (inverted)
Will not bind properly to
non-computer radio
Poor tail authority
Climb out rate is greatly
reduced
LED on receiver fl ashes
rapidly and aircraft will not
bind to transmitter
(during binding)
LED on receiver fl ashes
rapidly and aircraft will not
respond to transmitter (after
binding)
Helicopter vibrates or shakes
in fl ight
EN
Possible Cause
Throttle at high position
Switches not in normal position
Pitch or throttle servo reversing
improperly confi gured
Throttle hold on
Low battery voltage
Receiver uses default soft Low
Voltage Cutoff (LVC)
Stunt Mode switch still on
Throttle not at low position
Flight mode is set to Beginner Mode
Helicopter binds differently to
non-computer radios
Tail boom is cracked
The tail rotor blade is warped or bent
Main gear has slipped on the main shaft Push main gear back into position
Transmitter is too near aircraft during
binding process
Bind switch or button was not held
while transmitter was powered on
Aircraft or transmitter is too close to
large metal object, wireless source or
another transmitter
Less than a 5-second wait between
fi rst powering on transmitter and
connecting fl ight battery to aircraft
Aircraft is bound to a different model
TM
memory (ModelMatch radios only)
Flight battery/transmitter battery
charge is too low
Transmitter may have been bound to
a different model (or with a different
®
DSM Protocol)
Aircraft or transmitter is too close to
large metal object, wireless source or
another transmitter
Damaged rotor blades, spindle or blade
grips
Reset controls with throttle stick and throttle
trim at center or lowest setting
Set flight mode to OFF/0 and exit throttle hold
Reset servo reversing
Refer to "Programming your Transmitter"
Turn off HOLD with throttle low and trim
centered or low. Refer to "Throttle Hold"
Completely recharge fl ight battery
Recharge the flight battery or replace if the
battery performance is poor
Set flight mode to OFF/ 0 and exit throttle hold
Reset controls with throttle stick and throttle
trim at center or lowest setting
Switch the flight mode switch to Intermediate
or Experienced Mode before flying inverted
Release bind button/ switch after applying left
rudder. Do not hold the bind button/ switch
after applying left rudder
Replace tail boom
Twist rotor blade back into position or replace
Power off transmitter, move transmitter a
larger distance from aircraft, disconnect and
reconnect fl ight battery to aircraft and follow
binding instructions
Power off transmitter and repeat bind process
Move aircraft and transmitter to another
location and attempt binding again
Leaving transmitter on, disconnect and
reconnect fl ight battery to aircraft
Select correct model memory on transmitter
and disconnect and reconnect fl ight battery to
aircraft
Replace/recharge batteries
Select the right transmitter or bind to the new
one
Move aircraft and transmitter to another
location and attempt connecting again
Check main rotor blades and blade grips for
cracks or chips. Replace damaged parts.
Replace bent spindle
14
Solution