Controls - Qwic T-MN7 Bedienungsanleitung

Lighting indicator
Status indicator of (screen) lighting
Failure
See page 41 for failure codes
Battery percentage
Indicator of the information of the remaining
SET
battery-capacity
Battery charging-cycli
Indicator of the information of the total
charging-cycli -
Battery Voltage
Indicator of the information of the remaining
battery voltage
Walk-assist
Indicator of enabled Walk-assist
Driving-mode
Indicator of chosen driving-mode
SET
-

Controls

Switching On and Off
Press the 'ON/OFF' button for 2 seconds to turn the
system on and off. The control panel can only be used
when the battery is connected to the bike. When the
display is turned off while riding the bike, or when
riding without battery, it is possible that random
values are displayed as the motor generates small
powerstreams. Everything that appears on the display
when the system is not activated, can be ignored. If the
system is not used for 5 minutes it will shut itself down.
Selecting menus
Press shortly on 'SET' to choose between the total
distance, the trip distance, the range (kilometers or
miles), the range (minutes) and the timer.
Adjusting the pedal assistance
Use the 'PLUS' and 'MINUS' buttons to select the
assistance programs (0 - 8). Power level 8 gives the
strongest assistance. In power level 0 the motor gives
no assistance but you can use the display of the bike.
Please note that the battery runs out of power faster
when using a high power level than with a low power
level. Levels 1-5 are appropriate for flat roads, levels 6-8
are very powerful and only meant for hills, slopes and
tough circumstances.
Display & Controls: Rearmotor and frontmotor models 39