Controls & Display; Lcd Console; Battery - Qwic Premium I MN7+ Bedienungsanleitung

3.1 LCD Console

The display will only switch on if the battery is inserted in the bike and if
the battery is switched on. Press the 'ON/ OFF & STATUS' button on the

battery.

Functions & Controls
The LCD console is an easy to use display with integrated buttons. Switch
the display on by pressing the 'ON / OFF' button.
ON/OFF
SELECT
4
POWER LEVEL UP
LIGHT
38
14
km/h
5
RANGE 30 km
POWER LEVEL DOWN
WALK
Selection field
You can toggle through the functions of the selection field by briefly
pressing ' ON / OFF '
RANGE: An estimation of the amount of km you can still drive
TRIP DIST: The distance you covered since last trip
TRIP TIME: The time the display is turned on since last reset
ODO: Total distance
MAX SPEED: Maximum reached speed since last reset
AVG SPEED: Trip distance * Trip time
POWER:
The amount of power the motor is currently using in Watt
CALORY: An estimation of calories burnt in kCal
Lighting
Can be turned on/off by pressing ' + ' for 2 seconds. Remember that if
your bike runs out of battery your lights will also stop working
Battery indication
The status of your remaining battery capacity in 5 blocks of 20%. If the
battery gets below 5%, the first block will start blinking and you can start
noticing loss of support.
Power assist levels
The bike is fitted with 5 power levels . Toggle between them with '+' / '-'
Your dealer can also set your display to 3 or 9 levels if desired. This won't
affect the max. support power, but increases or decreases the amount
of steps between min. and max. support power The higher the power
level, the stronger the motor assistance. In power level 0 the motor
gives no assistance but you can use the display of the bike. Please note
that the battery runs out of power faster when using a high power level
than with a low power level. The highest level is very powerful and only
meant for hills, slopes and tough circumstances.
3. CONTROLS & DISPLAY