Inhaltsverzeichnis
Werbung
2
1, 2
Changing the Engine Oil
Run the engine a few minutes before changing the oil to warm it.
Warm oil fl ows better and carries more contaminants.
The engine oil will be hot. Avoid skin contact with the
used engine oil.
1.
Move snowthrower to a level surface.
2.
Run snowthrower until all fuel has been depleted.
3.
Remove key.
4.
Place an oil drain pan under the oil drain plug (1), remove the
oil drain plug, and tip the snowthrower backward and drain the
used oil in the oil drain pan.
5.
After draining the used oil, return the snowthrower to the op-
erating position.
6.
Screw in the oil fi ll cap/dipstick and hand tighten it securely (1).
NOTE: Dipstick location may vary depending on engine type.
7.
Clean around the oil fi ller cap (2).
8.
Unscrew and remove either side mounted fi ller cap dipstick or
high oil fi ll dipstick (2).
9.
With the snowthrower in the operating position, carefully pour
oil into the oil fi ll hole until "Full" on the fi ll cap/dipstick line.
Max fi ll: 18 oz. (0.5 L), type: automotive detergent oil with an
API service classifi cation of SJ, SL, or higher.
1
10. Screw in the oil fi ll cap/dipstick and hand tighten it securely.
11. Wipe up any spilled oil.
12. Dispose of the used oil properly at a local recycling center.
1
40
Werbung
Inhaltsverzeichnis
