Replacing The Power Cable - EINHELL TE-ID 1050/1 CE Originalbetriebsanleitung

the motor will now run as quickly as was set
at the speed controller (6).
•
The setting can also be made during opera-
tion.
Constant electronics
This tool is equipped with constant electronics.
With constant electronics, the set speed is kept
constant even when the tool is working under
load.
6.4 Clockwise/Counter-clockwise switch
(Fig. 6/Item 7)
•
Change switch position only when the drill is
at a standstill!
•
Switch the direction of the hammer drill using
the clockwise/counter-clockwise switch (7):
Direction
Clockwise (forwards and drill) Pushed in to the
Counter-clockwise (reverse)
6.5 Drill / hammer drill selector switch
(Fig. 7/Item 3)
•
Change switch position only when the
drill is at a standstill!
Drill:
Drill / hammer drill selector switch (3) in the drill
position. (Position A)
Use for: Wood, metal, plastic
Hammer drill
Drill / hammer drill selector switch (3) in the ham-
mer drill position. (Position B)
Use for: Concrete, rock, masonry
6.6 Defi ning the speed range (Fig. 8)
The speed selector switch (9) enables you to
work within a specifi c speed range.
Switch position, setting 1 (A)
Speed range: High torque, low speed
Switch position, setting 2 (B)
Speed range: Low torque, high speed
Important. Do not attempt to make this setting
whilst the drill is in use.
Anleitung_TE_ID_1050_1_CE_SPK7.indb 18 Anleitung_TE_ID_1050_1_CE_SPK7.indb 18
GB
6.7 Tips for working with your hammer drill
6.7.1 Drilling concrete and masonry
•
Switch the Drill/Hammer drill selector switch
(3) to position B (Hammer drill).
•
Always use carbide drill bits and a high speed
setting for drilling into masonry and concrete.
6.7.2 Drilling steel
Switch the drill / hammer drill selector switch (3)
to position A (drill).
•
Always use HSS drill bits (HSS = high speed
steel) and a low speed setting for drilling
steel.
•
We recommend that you lubricate the hole
with a suitable cutting fluid to prevent unne-
cessary drill bit wear
Switch position
6.7.3 Starting holes
right If you wish to drill a deep hole in a hard material
(such as steel), we recommend that you start the
Pushed in to the hole with a smaller drill bit.
left
6.7.4 Drilling tiles
•
To start the hole, switch the drill / hammer drill
selector switch (3) to position A (drill).
•
Switch the drill / hammer drill selector switch
(3) to position B (hammer drill) as soon as the
drill bit has passed through the tiles.

7. Replacing the power cable

If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
- 18 -
25.11.13 13:05 25.11.13 13:05