Functional Description/Emergency Release; Important Installation Instructions - Superrollo SR40070 Betriebsanleitung

i

Functional description/emergency release

In the event of a power cut, the door can be operated
manually by pulling the emergency release cable.
There is a risk of injury. The door can fall
un-controllably when it is released (e.g. if
springs are weak or broken, or if the door is
not properly balanced).
◆ Always close or open the door fully after each release.
◆ The emergency release is not intended for
„everyday use".

Important installation instructions

CAUTION
Important instructions for a safe installation.
Follow all installation instructions carefully.
An incorrect installation can lead to serious
injuries.
Before installation check...:
◆ ...whether your door operator is suitable for the type
of garage door and the garage door height.
◆ ...that the door is in a perfect mechanical state. The
door must be smooth running and be balanced.
Check whether it opens and closes properly;
Open the door approx. 1 metre and let go. A
balanced door should now remain in this position.
If not, have your door adjusted by a specialist
company.
◆ The door operation must not be hindered by in-
correctly adjusted springs or by incorrectly func-
tioning door suspensions or door constructions.
Before installing the drive...,
....remove all unnecessary ropes or chains and disable
any equipment, such as locks, not needed for powered
operation.
During installation there is a danger of injury
STOP
due to the unsecured door falling suddenly.
◆ During the installation work, ensure that there are
no persons in the swivelling area of the garage door.
Faulty installation can result in serious ac-
cidents and injuries.
◆ Fit the actuator for the emergency release at a
height of less than 1.8 metres.
◆ Use only the enclosed mounting materials and only
original spare parts and original accessories.
◆ Any existing door locking devices already fitted to
the door may hinder the correct functioning of the
door and must therefore be removed.
◆ Poor lighting hinders the installation work and can
result in injuries. Ensure that there is adequate
lighting during installation work.
◆ It is possible that during the installation work, you
may not be able to open the door for a short period
of time.
◆ Drive is not to be used with doors having openings ex-
ceeding 10 mm in diameter or having edges or protru-
ding parts a person could grip or stand on.
◆ Permanently fix the labels warning against entrapment
in a prominent place or near any fixed controls.
◆ Permanently fix the label concerning the manual release
adjacent to its actuating member.
EN
41