Important Notes After Installation; Attach Safety Notices With Warning Messages; Establish Operational Readiness Of The Door; Programming - Superrollo SR40070 Betriebsanleitung

Important notes after installation

◆ After installation, ensure that the mechanism is properly
adjusted and that the drive reverses when the door
contacts a 50 mm high object placed on the floor
(for drives incorporating an entrapment protection
system depending on contact with the bottom edge of
the door), s. page 61.

Attach safety notices with warning messages

Improper use results in an increased risk of
injury.
◆ Permanently fix the labels warning against entrapment
in a prominent place or near any fixed controls.
◆ Permanently fix the label concerning the manual release
adjacent to its actuating member.
◆ Attach all labels so that they are clearly legible.

Establish operational readiness of the door

1. Move the door carefully, in order to engage
the profile slide.
2. Plug the mains plug into the socket and
switch on the electricity.
3. The light goes on and the unit gives a single
beep and the display shows '0' at regular
intervals.

Programming

In order that the following settings are cor-
rectly stored and executed, you must carry
out a final programming procedure according
to page 56.
50
◆ After installation, ensure that the drive prevents or stops
the opening movement when the door is loaded with
a mass of 20 kg, fixed centrally on the bottom edge
of the door. This applies especially to drives which can
be used with a door that has openings in the door leaf
larger than 50 mm in diameter.
EN