Commissioning/Starting Up - HEYLO K 30 Bedienungsanleitung

Mobile warm-air heaters
Type K 30 / K30 T
6. Commissioning/start up
Heating
1. Connect the device to the oil supply lines through the flow connection and return port.
2. Plug in the mains plug in the appropriate mains supply socket.
3. If prescribed by the construction regulations, connect the chimney, else 1 m smoke tube with
rain hood.
4. Turn on the main switch to position -II- "heating." The burner will start up in the pre-
ventilation mode. After approx. 45 sec. the flame will ignite.
5. If the device and/or oil are cooled off, you will have to wait for 15 - 20 minutes depending on
the temperature until the oil pre-heating has pre-heated sufficiently. Only turn the main
switch on to the heating mode after this and, if it is being used, set the connected room
thermostat above ambient temperature.
6. Switching off: Turn off the main switch on the switch cabinet - do not pull out the mains
plug - since the ventilator must keep running for a short while after switching off to cool. The
temperature regulator will switch the ventilator off automatically with a delay of 2 -3 minutes.
This process can repeat itself a few times. Do not, therefore, pull out the mains plug to
switch the device off for any reason. If the device is turned off by pulling its plug or by pulling
at the main switch, the device cannot cool off afterwards and this can lead to damages to the
combustion chamber and to flame monitoring.
In certain circumstances, the safety temperature limiter can switch itself off and lock
automatically. The device will then only start up again after unlocking the safety temperature
switch.
Ventilation
1. Turn the main switch on to position –I- "ventilate."
2. To switch off ventilation: Set main switch to position -0- "Off."
Main switch
Socket for
room thermostat
26 EN