Cleaning The Device - Olympia ECS 510.3 CCD Bedienungsanleitung

When the waste bin is removed from the device, the shredder cannot be
Note:
used. The shredder only operates when the original waste bin is inserted
correctly.
9.2 Lubricating the cutting mechanism
To ensure a long service life for your paper shredder, we recommend clearing any
residue from the cutting mechanism regularly and applying a little special oil for paper
shredders on the cutting tool. You can obtain the special CFC-free oil from your supplier
or directly from our service centre in Hattingen. This helps lengthen the service life of the
device.
Each time the waste bin is emptied, apply several lines of the special oil in a lateral
●
direction on a suitable sheet of paper and feed this sheet through the shredder when
the ECS function is set.
It is forbidden to use oil spray from aerosol cans containing CFC!
Attention:
9.3

Cleaning the device

Safety note:
1. Set the On/Off switch to its OFF position and disconnect the power plug from the
power socket.
2. Clean the outside of the device with a soft, slightly damp cloth.
In order to clean the housing, do not use any aggressive, common house-
Note:
hold cleaning agents or any chemicals (e.g. solvents, petroleum ether). If
necessary, only use cleaning products specifically approved for cleaning
shredders.
It is not permitted to clean the shredder housing, infeeds or cutting mecha-
Note:
nism attachment with a pressure washer, compressed air or air duster.
It is forbidden to used easily inflammable substances. Risk
of injury!
23