AEG LAVATHERM 65278AC Benutzerinformation Seite 71

The loading door is opened.
The On/Off button was not
pushed.
The Start/Pause button was not
pushed.
The appliance is in the standby
mode.
Incorrect programme selection.
The filter is clogged.
The condenser is clogged.
Unsatisfac-
Too high volume of the load.
tory drying
results.
The airflow grill is clogged.
Dirt on the inner surface of the
drum.
Too high water hardness.
The filter not locked in the po-
The door
sition.
does not
The laundry is locked between
close.
the door and the seal.
You try to change the pro-
gramme or the function after
Err (Error)
the start of the cycle.
on the dis-
The function you try to activate
play.
is not applicable with the selec-
ted programme.
Abnormally
The time to end is calculated
elapsing
on the basis of the volume and
time on the
dampness of the laundry.
display.
Programme
The water container is full.
inactive.
To small laundry volume.
Drying cycle
too short.
The laundry is too much dried.
The filter is clogged.
Drying cycle
5)
too long Too high volume of the load.
Close the loading door.
Push the On/Off button.
Push the Start/Pause button.
Push the On/Off button.
Do the selection of the applica-
2)
ble programme.
3)
Clean the filter.
Clean the condenser.
Obey the maximum load vol-
ume.
Clean the airflow grill in the
bottom of the appliance.
Clean the inner surface of the
drum.
Set applicable water hard-
4)
ness .
Put the filter in the correct posi-
tion.
Put the load correctly in the
drum.
Turn the tumble dryer off and
on. Make the new selection.
Turn the tumble dryer off and
on. Make the new selection.
The automatic procedure —
this is not the appliance mal-
function.
Drain the water container
push the Start/Pause button.
Do the selection of time pro-
gramme.
Do the selection of time pro-
gramme or higher drying level
(e.g. Extra Dry )
Clean the filter.
Obey the maximum load vol-
ume.
ENGLISH
71
3)
3)
,