Installation; Precautions Before Installation; To Avoid Electromagnetic Interference; Before Installing - Pioneer AVIC-F9310BT Installationsanleitung

Installation

Precautions before
installation
CAUTION
! Never install this product in places where,
or in a manner that:
— Could injure the driver or passengers if
the vehicle stops suddenly.
— May interfere with the driver's opera-
tion of the vehicle, such as on the floor
in front of the driver's seat, or close to
the steering wheel or gearstick.
! Make sure there is nothing behind the
dashboard or panelling when drilling
holes in them. Be careful not to damage
fuel lines, brake lines, electronic compo-
nents, communication wires or power
cables.
! When using screws, do not allow them to
come into contact with any electrical lead.
Vibration may damage wires or insulation,
leading to a short circuit or other damage
to the vehicle.
! To ensure proper installation, use the sup-
plied parts in the manner specified. If any
parts other than the supplied ones are
used, they may damage internal parts of
this product or they may work loose and
the product may become detached.
! It is extremely dangerous to allow cables
to become wound around the steering col-
umn or gearstick. Be sure to install this
product, its cables, and wiring away in
such so that they will not obstruct or hin-
der driving.
! Make sure that leads cannot get caught in
a door or the sliding mechanism of a seat,
resulting in a short circuit.
! Please confirm the proper function of
your vehicle's other equipment after in-
stallation of the navigation system.
! Do not install this navigation system
where it may (i) obstruct the driver's vi-
sion, (ii) impair the performance of any of
the vehicle's operating systems or safety
features, including airbags, hazard lamp
buttons or (iii) impair the driver's ability
to safely operate the vehicle.
! Install the navigation system between the
driver's seat and front passenger seat so
that it will not be hit by the driver or pas-
senger if the vehicle stops quickly.
! Never install the navigation system in
front of or next to the place in the dash-
board, door, or pillar from which one of
your vehicle's airbags would deploy.
Please refer to your vehicle's owner's
manual for reference to the deployment
area of the frontal airbags.
To avoid electromagnetic
interference
In order to prevent interference, set the follow-
ing items as far as possible from this naviga-
tion system, other cables or leads:
! FM, MW/LW aerial and its lead
! GPS aerial and its lead
In addition, you should lay or route each aerial
lead as far as possible from other aerial leads.
Do not bind, lay or route them together, or
cross them. Electromagnetic noise will in-
crease the potential for errors in the vehicle's
location display.

Before installing

! Consult with your nearest dealer if installa-
tion requires drilling holes or other modifi-
cations of the vehicle.
! Before making a final installation of this
product, temporarily connect the wiring to
confirm that the connections are correct
and the system works properly.
Section
03
15
Engb