Setting The Date (By Quick Operation); Setting The Time - Lotus ILM6P27 Betriebsanleitung

SETTING THE DAY AND TIME (HOUR, 24 HOUR, MINUTE AND SECOND)

SETTING THE TIME

After setting the day, set the hour and minute hands.
Turn the hour/minute hands in a clockwise direction to set the time.
To ensure time is set accurately, first turn the minute hand 5 minutes ahead of desired
time and then turn back (in a counterclockwise) to the desired time.
After setting the time, use a time signal to synchronize the watch by pushing crown to
the normal position to start the second hand going.
NOTE:
Make sure you have correctly set AM/PM before setting the time.
When the day changes over, it is a.m..
(Day changes over between 0:00a.m. and 5:30a.m. or little later)
Check am./p.m. by the 24hour hand.
ILM6PS27/77
18
ILM6PS27/77

SETTING THE DATE (BY QUICK OPERATION)

Pull the crown out to the 1st position. Turn the crown counterclockwise to set
the date quickly.
NOTE:
* Do not set the date between the hours 9:00p.m. and 0:30a.m.. The date
may not change correctly the next day.
19